Buy Free DTH Power Supply Circuit (MPEG-2 Only)

Buy Free DTH Power Supply Circuit (MPEG-2 Only)

Input: 220 V AC

Switch Mode Circuit(SMPS) - No transformer

Output : DC voltage via 6 pin header(+33V, Gnd, +12V, +24V, Gnd

This power supply board is compatible with the most common mpeg-2 boxes available in the local market.

It is a universal Power Supply Circuit Board for free dth MPEG-2 Set Top Box Satellite Receiver Changeable SMPS PCB and a reliable and high-quality power supply circuit board.

Warranty: 1 Month from date of purchase, selfship is required.

How to change the free dth power supply circuit?

Changing the power supply circuit of a free DTH (Direct-to-Home) setup can be a bit technical, but here are some general steps to guide you through the process:

1. Ensure the DTH setup is unplugged from the power source to avoid electrical hazards.
2. Use a screwdriver to open the DTH set-top box carefully. Be gentle to avoid damaging any internal components.
3. Identify the power supply board inside the DTH box. It is usually a small circuit board connected to the main board.
4. Carefully disconnect the power supply board from the main board. This may involve unplugging connectors or desoldering wires.
5. Obtain a compatible replacement power supply board. Connect it to the main board by plugging in the connectors or soldering the wires as needed.
6. Before closing the DTH box, plug it in and turn it on to ensure the new power supply works correctly.
7. Once you confirm that everything is functioning properly, close the DTH box and secure it with screws.

If you’re not comfortable doing this yourself, it might be best to consult a professional technician to avoid any potential damage or safety risks. take your responsibility for any risk.

Note: You may receive different color, brand, and make as per our stock.